Job 10: Pattern Note Assign; Job 11: Device Number; Job 12: Bulk Transmit - Yamaha RY30 Authorized Product Manual

UTILITY MODE
Note numbers in the ten-octave range be-
tween C-2 (0) and C8 (120) can be used to con-
trol the pitch of the selected voice. C3 (60) pro-
duces normal pitch.

JOB 10: PATTERN NOTE ASSIGN

Summary: Assigns specific MIDI program change
numbers or note numbers to RY30 pattern num-
bers. The program change or note numbers then
received on a MIDI channel set to "PTN" (as
described in the "RECEIVE CHANNEL" func-
tion on page 71) will select the corresponding
pattern.
Settings: Type: PRG (program change number),
NOTE (note number)
Program or note number: PRG = 000 . . . 127
NOTE = C-2 (000) . . . G8 (127)
Pattern number: 000 . . . 199
Procedure: Use the
the type parameter if necessary, and use the
[INC] and [DEC] keys or [DATA] slider to
select "PGM" for program change numbers or
"Note" for note numbers, as required. Use the
and keys to move the cursor to the pro -
gram/note number or pattern number parameter,
then use the [INC] and [DEC] keys, the
[DATA] slider, or the numeric keys to set as
required.
Notes: The ability to trigger patterns via MIDI pre -
sents a range of possibilities for new stage and
studio automation techniques.

JOB 11: DEVICE NUMBER

74
key to move the cursor to
Summary: Sets the RY30 MIDI device number —
i.e. the MIDI channel on which all system
exclusive data will be received and transmitted.
Settings: Device number: OFF, 1 . . . 16, ALL
Procedure: Use the [INC] and [DEC] keys or the
[DATA] slider to select the desired device
number or turn system exclusive reception/
transmission off.
Notes: The device number is important for transfer
of voice data and other system exclusive data be-
tween the RY30 and other Yamaha MIDI devices
— e.g. another RY30, a MIDI sequence recorder,
etc. Make sure that the RY30 device number is
matched to that of other devices in your system
with which bulk data transfers will take place
(see "BULK TRANSMIT", below).
"Receiving bulk dump!" will appear on the
display while a bulk dump is being received from
another MIDI device (as long as an appropriate
device number is set and the RY30 is not in the
play or record mode).

JOB 12: BULK TRANSMIT

Summary: Initiates MIDI bulk transmission of all
data or a single voice.
Settings: Type: All, Voice
Source voice: (when "Voice" selected): I00 . . .
I95 (internal), C00 . . . C31 (card)
Destination voice: (when "Voice" selected): I00
. . . I95 (internal)
Procedure: Use the [INC] and [DEC] keys or the
[DATA] slider to select "All" or "Voice."
If "Voice" is selected, use the
keys to move the cursor to the source or desti-
nation voice parameter, then use the [INC] and
[DEC] keys or the [DATA] slider to select the
voices.
and