Job 02: Cassette Verify; Job 03: Cassette Load - Yamaha RY30 Authorized Product Manual

UTILITY MODE
Load a good quality cassette tape into the
recorder, run the pate to a point past the leader,
engage the record mode, then press the RY30
[ENTER] key. "Cassette Saving Now!" will
appear on the display while the data is being
recorded.
When "Complete!" appears on the display,
stop the cassette recorder.
Notes: Data saved by this job includes all pattern
data, all song data (including song names and
initial tempos), all voice data including all
editable voice parameters, and all setup data (i.e.
MIDI function settings and PAD BANK settings).
The cassette save operation can be inter-
rupted at any time by pressing the [STOP/
CONTINUE] key. If this is done, "Break!" will
appear on the display.

JOB 02: CASSETTE VERIFY

Summary: Compares the data recorded on the cas-
sette tape with that in the RY30 memory to
verify that a save operation has been successful.
Settings: None
Procedure: Cassette recorder connections are the
same as for JOB 01: CASSETTE SAVE.
Rewind the tape to a point before
ning of the recorded data, press the RY30
[ENTER] key, then start playback of the cas-
sette. "Cassette Verifying Now!" will appear on
the display while the RY30 is reading the data
from the cassette and comparing it with the data
in memory. "Complete!" will appear once the
verify operation has been finished and the cas-
sette data proves to be OK.
If an error in the data is detected, the
"Verify Error!" message will appear on the dis-
play. If this happens, try saving and verifying the
data again. If the error persists, you may need to
adjust the level settings of your cassette
recorder or use a different tape.
70
Notes: It is important to use the cassette verify job
Summary: This job reloads data you have previ-
Settings: None
Procedure: Cassette recorder connections are the
begin-
the
Notes: The cassette load operation can be inter-
immediately after saving data using the cassette
save job, otherwise any changes you make to the
RY30 memory contents after saving the data
might be interpreted by the RY30 as a verify
error.
The cassette verify, operation can be inter-
rupted at any time by pressing the [STOP]
CONTINUE] key. if this is done, ''Break!" will
appear on the display.

JOB 03: CASSETTE LOAD

ously saved to cassette tape using the CAS-
SETTE SAVE function described on page 69.
same as for JOB 01: CASSETTE SAVE.
Rewind the tape to a point before the begin-
ning of the recorded data and press the RY30
[ENTER] key. "Sure" will appear on the dis-
play. Press the [ENTER] key again, then start
playback of the cassette. "Cassette Loading
Now!" will appear on the display while the
RY30 is loading the data from the cassette.
"Complete!" will appear once the data has been
loaded.
If an error is detected during the load opera-
tion, the "Load Data Error!" message will
appear on the display. You might have to adjust
the recorder's volume control to find the right
level for loading data into the RY30.
rupted at any time by pressing the [STOP/
CONTINUE] key. If this is done, "Break!" will
appear on the display and all internal data will be
initialized.
All data in the RY30 memory will be replaced
by the loaded data.