Rear Panel - Yamaha RY30 Authorized Product Manual

n Rear Panel
[POWER] Switch
Press to turn the RY30 power ON or OFF.
DC 15V 500mA IN Jack
The DC output cable from the supplied AC
Adaptor should be connected here. When con-
necting the power supply, make sure that the
RY30 POWER switch is in the OFF position
(extended), then plug the AC adaptor output
cable into the DC 15V 500mA IN jack, and
finally the adaptor's AC plug into a convenient
AC wall outlet.
CAUTION!
Do not attempt to use a different AC adaptor to
power the RY30. The use of an incompatible
adaptor may cause irreparable damage to the
RY30, and might pose a serious shock hazard!
PHONES Jack
Accepts a standard pair of stereo headphones
(1/4" stereo phone plug) for headphone monitor-
ing of the RY30 sound without the need for
external amplification equipment.
OUTPUT L/MONO & R Jacks
These are the main stereo outputs from the
RY30. If a plug is inserted only into the
L/MONO jack of an output pair, the left and
right-channel signals are combined and delivered
via this jack (for connection to a monaural sound
system). Instruments can be individually as-
signed to these outputs only, these outputs and
either or both of the INDIV outputs described
below, or either or both of the INDIV outputs
only (page 90). The [VOLUME] control controls
the level of the signal sent to these jacks.
INDIV OUT 1 & 2 Jacks
Each RY30 instrument can be assigned to both,
either, or neither of these jacks in addition to the
stereo outputs described above. Further, the
level at which each instrument will be delivered
via these jacks can be controlled independently
of the stereo outputs (page 90). The [VOL-
UME] control does not affect the INDIV OUT
jack signal.
11