Song Name; Song Events; Begin Repeat - Yamaha RY30 Authorized Product Manual

Song Name

l l Song Events

Begin Repeat

38
With the cursor at the ON/OFF parameter, use the [INC] key or the
[DATA] control to turn the function ON if you want the initial tempo to be
active. Press to move the cursor to the tempo parameter, and use the [INC]
and [DEC] keys, the [DATA] control, or the numeric keys to enter the desired
initial tempo.
Press the [EXIT] key to return to the song edit mode, or use the [PAGE–]
and/or [PAGE+] keys to locate another job if necessary.
Well-thought-out names make it easier to identify songs.
Use the and
acter locations within the NAME brackets. Use the numeric keys, the [INC] or
[DEC] keys, or the [DATA] slider to enter the characters for the voice name
see "Give Your Pattern a Name" on page 28 for details on how to use the
numeric keys and a list of the available characters). Your original pattern name
will be displayed in the brackets on the top display line when that song is
selected.
Press the [EXIT] key to return to the song edit mode, or use the [PAGE–]
and/or [PAGE+] keys to locate another job if necessary.
In addition to pattern numbers, the RY30 provides the following events for use
in songs. Normally you'll use the Insert job described in the previous section to
insert any of these events in the required location.
The different event types are specified by the TYPE parameter on the top
line of the song edit display, and are selected in sequence by pressing the
numeric [–] key (look for the "EVENT TYPE" label below the key).
Please note that the event types listed below can only be selected for a part
number that does not already contain data
operation, or the part after the last existing part in the song. In either case, the
TYPE and event parameters will flash to indicate that the part does not contain
data.
Insert a begin repeat event before a part or group of parts you want to re-
peat one or more times. A begin repeat must always be accompanied by an end
repeat event (see below) which defines the end of the song segment to be
repeated.
After selecting the Begin Repeat event, press the [ENTER] key to actually
enter it into the current part number and advance to the next part number.
keys to move the cursor to one of the 6 available char-
—
i.e. a part cleared by an Insert