Yamaha RY30 Authorized Product Manual page 62

PATTERN MODE
Summary: Appends the pattern from the second
pattern number to the end of the first pattern
number and stores the result to the destination
pattern number.
Settings: First pattern number: 000 . . . 199
Second pattern number: 000 . . . 199
Destination pattern number: 000 . . . 099
Procedure: Use the
cursor to the first, second, or destination pattern
number. Use the [INC] and [DEC] keys, the
[DATA] slider, or the numeric keys to set the
appropriate pattern numbers.
Press the [ENTER] key — "Sure" will
appear on the display. Press the [ENTER] key
again to append and store the pattern or press
[EXIT] to cancel the operation. "Complete!"
Summary: Divides the source pattern at the speci-
fied divide measure, leaving the first part of the
pattern in the source pattern number and storing
the second part of the pattern in the destination
pattern number.
Settings: Source pattern number: 000 . . . 099
Destination pattern number: 000 . . . 099
Divide Measure: 2 . . . 4
Procedure: Use the
cursor to the source or destination pattern num-
ber, or to the divide measure parameter. Use the
[INC] and [DEC] keys, the [DATA] slider, or
the numeric keys to set the selected parameter
as required.
54
PATTERN APPEND
keys to move the
and
PATTERN DIVIDE
and keys to move the
will appear on the display briefly when the pat-
terns have been appended and stored.
Notes: Since the maximum length of any pattern is 4
measures, the total length of the two patterns to
be joined by the pattern append function must be
no more than 4 measures. Both the first and set -
ond patterns must also have the same time
signature.
Any previous data in the destination pattern
number will be erased and replaced by the
appended pattern.
"! Memory Full !" will appear on the display
if there is not enough pattern memory available
for the appended.
If the pattern produced by the append opera-
tion is too large, "!Too Large Pattern!" will ap-
pear on the display. If either of the specified
source patterns contain no data, the "Illegal
Input !" error message will appear. If the source
and destination patterns contain no data, the
"! No Data Converted !" error message will
appear.
Press the [ENTER] key — "Sure" will
appear on the display56.
Press the [ENTER] key again to divide the pattern
or press [EXIT] to cancel the operation.
"Complete!" will appear on the display briefly
when the pattern has been divided.
Notes: This is a great way to slice off a section of a
pattern you want to use by itself, or as a basis for
a new pattern.
Any previous data in the destination pattern
number will be erased and replaced by the second
part of the divided pattern.
If you specify, a source pattern that contains
no data, the "!No Data Converted!" error mes-
sage will appear on the display when the opera-
tion is executed, and the operation will be
c a n c e l l e d .
"! Memory Full !" will appear on the display
if there is not enough pattern memory available
to complete the operation.
Pattern mode/Page 04
Pattern mode/Page 05