Cisco XR 12406 Installation Manual page 216

Removing and Installing a Clock and Scheduler Card, Switch Fabric Card, or Alarm Card
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Verifying the Installation of the Clock Scheduler Card
Cisco XR 12406 Router Installation Guide
5-52
Grasp the card ejector levers and pivot them away from the CSC faceplate (see
Figure 5-32).
Slide the CSC halfway out of the slot, then stop.
Touching only the metal card carrier, use your free hand to support the bottom of
the CSC and slide the card completely out of the chassis.
Always place the CSC directly into an antistatic bag or other ESD-preventive
•
container.
If you plan to return the defective CSC to the factory, repackage it in the
•
shipping container you received with the replacement card.
Set both edges of the CSC carrier into the card slot carrier alignment grooves on
either side of the CSC slot and slide the card halfway into the chassis.
Pivot the ejector levers outward away from the faceplate.
Slide the card into the CSC slot until the ejector levers make contact with the front
of the card cage, then stop.
Pivot the ejector levers toward the faceplate until the connector properly seats in
the backplane.
Tighten the two captive screws.
Do not overtighten the captive screws; over tightening can strip the
Caution
threads on the screw or in the insert in the CSC faceplate.
To verify router operation after installing a replacement CSC, see the
the Installation of Alarm Cards, Clock Scheduler Cards, and Switch Fabric Cards"
section on page 5-57.
Chapter 5 Maintaining the Router
"Verifying
OL-13831-01