Cisco XR 12406 Installation Manual page 174

Removing and Replacing the Blower Module
Install the new blower module
Step 2
a.
b.
Electrical and control line connections for the blower module and backplane
Caution
occur automatically when the connectors on the blower module and PDU mate.
To prevent damage to the blower module and PDU connectors, do not use
excessive force when installing the blower module against the rear of the chassis.
c.
d.
Cisco XR 12406 Router Installation Guide
5-10
Position the alignment holes on the blower module with the guide pins at the
top of the chassis and on the PDU at the bottom of the chassis.
Slide the blower toward the chassis until it mates with the backplane
connector.
Tighten the four captive screws to secure the blower module to the chassis.
The (green) OK indicator should be on. If the OK indicator is not on, see the
"Troubleshooting the Blower Installation" section on page
Lower the blower module handle to its operating position.
Chapter 5
(Figure 5-5):
Maintaining the Router
5-12.
OL-13831-01