Cisco XR 12406 Installation Manual page 207

Chapter 5 Maintaining the Router
Use the following procedure to remove and replace an RP or line card.
Identify the RP or line card to be replaced and write down the following
Step 1
information:
•
•
•
On cards with multiple ports, start with the left port on the card and disconnect
Step 2
the interface cable connectors from each of the ports.
After all the interface cables are disconnected, loosen the two captive screws on
Step 3
the cable-management bracket and pull the bracket away from the card.
Loosen the two ejector lever captive screws at each end of the line card faceplate.
Step 4
OL-13831-01
The RP cable connections on the RP.
The number and type of RP or line card, so that you will know the location of
the card when you re-install it or the replacement, in the card cage.
The network interface cable connection ports, on the RP or line card.
Removing and Replacing an RP or a Line Card
Cisco XR 12406 Router Installation Guide
5-43