Cisco XR 12406 Installation Manual page 213

Chapter 5 Maintaining the Router
Proceeding from the left port on the line card to the right port (on line cards with
Step 6
multiple ports), identify the network interface cable for the line card port and
insert the cable connector into the line card port (see
a.
b.
Note
Step 7 Secure the interface cables to the cable-management bracket by wrapping the
velcro straps around them (see
Note
OL-13831-01
Align the interface cable with the cable-management bracket.
Repeat for the remainder of the interface cables for this line card.
Carefully adjust the interface cables in the cable-management bracket to
prevent any kinks or sharp bends in the interface cables. Kinks and sharp
bends can destroy or degrade the ability of the optical fiber to propagate
the signal-encoded beam of light accurately from one end of the cable to
the other. Also, allow adequate strain relief in the interface cables.
Do not wrap the velcro straps too tightly.
Removing and Replacing an RP or a Line Card
Figure 5-30).
Cisco XR 12406 Router Installation Guide
Figure 5-30).
5-49