Cisco XR 12406 Installation Manual page 127

Chapter 3 Installing the Cisco XR 12406 Router
RP Interfaces Using the RP LEDs
Note
OL-13831-01
Table 3-7 LED Display Meaning and Signal Source (continued)
LED
Display Meaning
RP A valid Cisco IOS XR image is running.
UP
PRI The RP is enabled and recognized as the system primary.
RP A valid Cisco IOS XR image is running.
SEC The RP is enabled and recognized as the system
RP secondary. A valid Cisco IOS XR image is running.
1. The version of MBus microcode running on your system might be different.
The Cisco XR 12000 Series Router uses the performance route processor
(PRP-2).
When not explicitly specified, this publication uses the term route processor (RP)
to indicate the PRP.
The RJ-45 port LEDs on the RP indicate the following conditions:
• System and RP status
Which Flash memory card slot is active
•
Which Ethernet connection is in use
•
What is occurring on the Ethernet interface
•
The alphanumeric LED displays indicate a successful RP boot.
Manually Booting the System
Cisco XR 12406 Router Installation Guide
Source
RP IOS
XR
software
RP IOS
XR
software
RP IOS
XR
software
3-39