Cisco XR 12406 Installation Manual page 188

Removing and Replacing an AC PDU
Step 9
Caution
Figure 5-13 Installing the Blower Module
HIG H SPE ED
BLO WE R
Step 10
Step 11
Step 12
Cisco XR 12406 Router Installation Guide
5-24
Install the blower module
Position the alignment holes on the blower module with the guide pins on the
a.
chassis and PDU.
Slide the blower over the guide pins toward the chassis until it mates with the
b.
PDU connector.
To prevent damage to the connectors, do not use excessive force when installing
the blower module.
Tighten the (4) captive screws to secure the blower module to the chassis.
c.
Lower the carrying handle to its operating position.
d.
Reconnect the power cords to the PDU and secure them using their retention clips.
Plug the power cords into their AC outlets.
Power on the circuit breakers assigned to the AC outlets.
(Figure 5-13):
Chapter 5 Maintaining the Router
OL-13831-01