Cisco XR 12406 Installation Manual page 211

Chapter 5 Maintaining the Router
Use the following procedure to attach the cable-management bracket and cables
to a line card.
Orient the top of the cable-management bracket with the top of the line card
Step 1
faceplate (the end opposite the two four-character alphanumeric displays.)
Align the two captive screws on the bracket with the threaded insert holes near the
Step 2
ejector levers on each end of the line card faceplate and finger-tighten the screws.
Use a flat-blade screwdriver to secure the two captive screws.
Step 3
Caution
Figure 5-29
Repeat steps 1 through 3 for any remaining line cards.
Step 4
OL-13831-01
Do not overtighten the captive screws; overtightening the screws can
strip the threads on the screw or the insert in the faceplate.
Line Card Cable-Management Bracket
Removing and Replacing an RP or a Line Card
For fiber-optic or
copper cable
line cards
Cisco XR 12406 Router Installation Guide
5-47