Set up, install, and configure
Setting up the fax function using analog fax
Notes:
•
A fax card must be installed for the printer to use analog fax.
•
Some connection methods are applicable only in some countries or regions.
•
If the fax function is enabled and not fully set up, then the indicator light may blink red.
•
If you do not have a TCP/IP environment, then use the control panel to set up fax.
Warning—Potential Damage: To avoid loss of data or printer malfunction, do not touch cables or the printer
in the area shown while actively sending or receiving a fax.
Using the Settings menu in the printer
1
From the home screen, touch Settings > Fax > Fax Setup > General Fax Settings.
2
Configure the settings.
Using the Embedded Web Server
1
Open a web browser, and then type the printer IP address in the address field.
Notes:
•
View the printer IP address on the home screen. The IP address appears as four sets of numbers
separated by periods, such as 123.123.123.123.
•
If you are using a proxy server, then temporarily disable it to load the web page correctly.
2
Click Settings > Fax > Fax Setup > General Fax Settings.
3
Configure the settings.
4
Apply the changes.
40