Table of Contents
Advertisement
15 WIRING HARNESS, BATTERY
15.7
15.8
146
Checking the charging voltage
Checking the open-circuit current
Alternative 3
CH battery charger
(00029095053)
(a
•
Info
I
Follow the instructions of the charger and the manual.
-
Disconnect the battery charger after charging the battery.
Guideline
The charging current, charging voltage, and charging time
must not be exceeded.
Charge the battery regularly
when the motorcycle is not
in use
Finishing work
-
Mount the seat.
(a
p. 97)
Condition
The battery must be fully functional and completely charged.
Preparatory work
-
Remove the seat.
(a
p. 97)
Main work
-
Carry out the start procedure.
Measure the voltage between the specified points.
V
Measuring point
Ground(-)
Charging voltage
I
5,000 rpm
If the displayed value is less than the specified value:
-
Check the plug-in connections from the alternator to
the voltage regulator.
-
Check the plug-in connections from the voltage regu-
lator to the wiring harness.
-
Check the stator winding of the alternator.
If the displayed value is greater than the specified value:
-
Change the voltage regulator.
Preparatory work
(FE EU/AU)
-
Press and hold the kill switch (5s) while the engine is idling
until the engine stops.
(FE 350 US)
-
Press and hold the kill switch (5s) while the engine is idling
until the engine stops.
XCharge-professional
p. 357)
3 months
(@]I
p. 13)
(+) - Measuring point
Plus
113.5 ... 15.0 V
(a
..
p. 265)
..
Advertisement
Table of Contents
