Husqvarna FE 350 2016 Repair Manual page 199

Blow out oil nozzle
is clear.
Guideline
Oil nozzle for
balancer shaft
lubrication
Insert the new cold bearings into the bearing seats of the hot
engine case section and, if necessary, use a suitable press
drift to push the bearing all the way to the stop or so that it is
308660-10
flush.
Info
When pressing the bearing in, ensure that the engine
case section is level to prevent damage.
Only press the bearings in via the outer bearing race;
otherwise, the bearings will be damaged when they
are pressed in.
After the engine case section has cooled, check that the
bearings are firmly seated.
Info
If the bearings are not firmly seated after cooling, it
is likely that they will rotate in the engine case when
warm. In this case, the engine case must be renewed.
Mount the dowels.
Press in shaft seal ring
side facing out so it is flush.
Mount and tighten nozzle
Guideline
Nozzle, crank
chamber venti-
lation
Mount and tighten oil nozzle (5).
Guideline
Oil nozzle for
conrod bearing
lubrication
Mount the oil nozzle for piston cooling.
Mount and tighten screw
Guideline
Screw, oil noz-
zle for piston
cooling
Position all bearing locks.
Mount and tighten screws
Guideline
Locking screw
for bearing
(D
with compressed air and check that it
M4 2 Nm (1.5 lbf ft)
Loctite
O
of the crankshaft with the open
8.
M4 2 Nm (1.5 lbf ft)
Loctite
M4 2 Nm (1.5 lbf ft)
Loctite
8.
M4 2 Nm (1.5 lbf ft)
Loctite
@).
M5 6 Nm (4.4 lbf ft)
Loctite
18 ENGINE
®
243 ™
®
243 ™
®
243
™
®
243
™
®
243
™
197