Adding Front Brake Fluid - Husqvarna FE 350 2016 Repair Manual

Adding front brake fluid

Warning
Danger of accidents
If the brake fluid level drops below the specified marking or the specified value, the brake system is
leaking or the brake linings are worn down.
Check the brake system and do not continue riding until the problem is eliminated.
A
Warning
Skin irritation Brake fluid causes skin irritation.
Keep brake fluid out of the reach of children.
Wear suitable protective clothing and safety glasses.
Do not allow brake fluid to come into contact with the skin, the eyes or clothing.
Consult a doctor immediately if brake fluid has been swallowed.
Rinse the affected area with plenty of water in the event of contact with the skin.
Rinse eyes thoroughly with water immediately and consult a doctor if brake fluid comes into contact
with the eyes.
If brake fluid spills on to your clothing, change the clothing.
A
Warning
Danger of accidents
Make sure that brake fluid for the front and rear brake is changed in accordance with the service
schedule.
Warning
Environmental hazard
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not
designed for DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
An insufficient brake fluid level will cause the brake system to fail.
Old brake fluid reduces the braking effect.
Hazardous substances cause environmental damage.
Preparatory work
Check the front brake linings.
Main work
(FE EU/AU, FE 350 US)
Move the brake fluid reservoir mounted on the handlebar
to a horizontal position.
Remove screws
Remove cover
-
Add brake fluid to level f) .
Guideline
Level f) (brake fluid level
below reservoir rim)
Brake fluid DOT 4
16
(� p. 148)
O.
8 8.
with membrane
5 mm (0.2 in)
(!,l p. 352)
BRAKE SYSTEM
153