Husqvarna FE 350 2016 Repair Manual page 271

@).
Remove gasket
Remove screw Gi).
Turn the crankshaft counterclockwise until markings
the cylinder head are flush with the flat areas
camshafts.
Info
Make sure that the crankshaft is at top dead center.
48.
Remove screw
Remove washer �.
Look through the hole to check that the position notch of the
crankshaft is visible.
48
Mount and tighten screw
On all valves, check the valve clearance between the
camshaft and cam lever with the special tool.
Guideline
Valve clearance
Intake at: 20 °C (68 °F)
Exhaust at: 20 °C (68 °F)
I
Feeler gauge (59029041100)
If the valve clearance does not meet specifications:
-
Adjust the valve clearance.
23 CYLINDER HEAD
f)
on
@)
of the
without the washer.
0.10 ... 0.15 mm (0.0039 ...
0.0059 in)
. . .
0.13 ... 0.18 mm (0.0051
0.0071 in)
(!:l p. 360)
(!:l p. 271)
269