Table of Contents
Advertisement
6 FORK, TRIPLE CLAMP
30
804094-10
Assemblin
the cartrid e
Info
The operations are the same on both fork legs.
-
Grind the piston on both sides on a surfacing plate using
1200 grit sandpaper.
-
Clean the piston.
-
Lubricate the piston ring.
I Fork oil (SAE 4) (48601166S1)
-
Mount the piston with chamfer
-
Mount rebound shim stack
upward.
Info
Note the setting list.
-
Press the piston downward against the spring.
Info
Make sure the pistons do not squeeze the shims.
-
Position valve @ in hydrostop needle
the hydrostop needle.
Guideline
Hydrostop needle on
piston rod
•
Info
-
e
I
silver hydrostop needle on compression damp
ing side.
G) - red hydrostop needle on rebound damping side.
-
Unclamp the piston rod.
Preparatory work
-
Assemble the seal ring retainer.
-
Assemble the piston rod.
(11\:!
p. 352)
f)
facing down.
(D
with the smaller shims facing
fD.
Mount and tighten
M6x0.5
8 Nm (5.9 lbf ft)
(11\:!
p. 28)
(11\:!
p. 29)
Advertisement
Table of Contents
