Installing The Battery; Checking The Charging Voltage; Checking The Quiescent Current - Husqvarna FC 450 2014 Repair Manual

15
WIRING HARNESS, BATTERY
15.4
15.5 Checkin the quiescent current
-
Main work
Position the battery in the battery compartment with the terminals facing forward.
I
Battery (YTX5L-BS)
-
Reconnect rubber band
• Info e
Contact disk
I
with the claws facing down.
-
Position the positive cable and mount and tighten the screw.
Guideline
Screw, battery terminal
Slide positive terminal cover
-
Position the negative cable and mount and tighten the screw.
Guideline
Screw, battery terminal
-
Slide negative terminal cover
-
Finishing work
Mount the seat. (.- p. 79)
e
Condition
The battery must be fully functional and completely charged.
-
Preparatory work
Remove the seat. (.- p. 79)
-
Main work
Pull back the positive terminal cover.
-
Start the motorcycle for a check. (.- p. 11)
Measure the voltage between the specified points.
Measuring point
Charging voltage
I
5,000 rpm
If the displayed value is less than the specified value:
-
Check the plug-in connections from the alternator to the voltage regulator.
-
Check the plug-in connections from the voltage regulator to the wiring
harness.
-
Check the stator winding of the alternator. (.- p. 195)
If the displayed value is greater than the specified value:
-
Change the voltage regulator.
-
Finishing work Mount the seat. (.- p. 79)
-
Preparatory work
Switch off all power consumers and switch off the engine.
-
Remove the seat. (.- p. 79)
O.
must be mounted between screw
M5
over the positive terminal.
8
M5
over the negative terminal.
8
(+) - Measuring point
Plus Ground
1 .5 ... 15.0 V
1 3
106
e
and cable lug
0
2.5 Nm
(1.84 lbf ft)
2.5 Nm
(1.84 lbf ft)
(-)