Installing An Internal 3.5-Inch Hard Drive - Compaq dc5800 - Microtower PC Hardware Reference Manual

Hardware reference guide - dc5800 microtower model
Hide thumbs Also See for dc5800 - Microtower PC:
Table of Contents

Advertisement

Installing an Internal 3.5-inch Hard Drive

NOTE:
The system does not support Parallel ATA (PATA) hard drives
1.
Install the four guide screws (two on each side) that were removed from the old drive into the new
drive. The screws help guide the drive into its proper position in the bay. Extra guide screws are
provided on the interior of the chassis frame next to the power supply.
Figure 2-28
NOTE:
installed on the interior of the chassis frame next to the power supply. The HP-supplied isolation
mounting guide screws are silver and blue. Refer to
illustration of the extra 6-32 isolation mounting guide screws location.
If you are replacing a drive, transfer the guides screws from the old drive to the new one.
2.
Slide the drive into the drive bay, making sure to align the guide screws with the guide slots, until
the drive snaps into place. The upper bay is for the primary hard drive. The bottom bay is for an
optional secondary hard drive.
Figure 2-29
34
Chapter 2 Hardware Upgrades
Installing Hard Drive Guide Screws
The hard drive uses 6-32 isolation mounting guide screws. Four extra guide screws are
Sliding a Hard Drive into the Drive Bay
Installing Additional Drives on page 23
for an
ENWW

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nv313ut#abaKa435ut

Table of Contents