Removing a Cooling Shield for a Hard
Drive Installation
A cooling shield covers bays 5 and 6 to provide proper cooling and EMI
protection. You will need to remove a cooling shield before installing a hard
drive in either of these bay locations.
To remove a cooling shield:
1. Turn off the workstation and disconnect the power cord from the
grounded AC outlet and the back of the workstation.
2. Remove the side access panel and front bezel.
3. Refer to the following illustration to remove a cooling shield.
Figure 8-4.
IMPORTANT:
in the bay.
To replace the cooling shield, reinsert the two screws.
Removing a cooling shield
You will need to replace the shield after the drive is installed
ACT
CO MP
Compaq Professional Workstation SP700 Reference Guide
8-5