Reading The Identification Data Of A Cassette (Dedicated Configuration Only) - AGFA CR 35-X User Manual

Reading the identification data of a
cassette (Dedicated configuration
only)
In the dedicated configuration, the identification data stored in the memory
chip of the cassette can be read via the CR 35-X.
To read the identification data of a cassette:
1 Check that the CR 35-X is ready for operation:
•
The CR 35-X must display the operator main screen with 'Ready' status, e.g.:
QS not ready
•
The status indicator at the top of the CR 35-X must be green and be lit constantly.
Note: The CR 35-X is operational if the status field equals 'READY', even if
status messages of the destination are shown (e.g. 'QS not ready').
2
In the ID Software on the ID Station, select the mode for reading cassettes.
Refer to the User manual of the ID Software.
The display of the CR 35-X will read:
READ CASSETTE MODE
Enter cassette or press
4454C EN 2013-05-14
READY
BUSY
DIRECT ID
to cancel

Reading the identification data of a cassette (Dedicated configuration only)

CR 35-X D
IGITIZER
Status field
59