AGFA CR 35-X User Manual page 47

or press
The CR 35-X converts the information of the latent image to digital data.
Note: If the CR 35-X displays an error message, refer to
operation ('Key-operator
4
Enter the identification data via the ID Station.
For detailed information, refer to the User manual of the ID Software.
As soon as you have entered the identification data, the CR 35-X displays:
Miller
As soon as the CR 35-X has digitized the entire image plate and you have entered the
identification data:
• the CR 35-X erases the image plate and re-inserts it into the cassette;
• the CR 35-X gives the cassette ID data the status 'erased'.
• the cassette is returned to the cassette slot;
• the digital image data is sent to the image processing station ('destination').
When the CR 35-X has treated the cassette, it displays the operator main screen.
5
Remove the cassette from the cassette slot.
WARNING:
used immediately. However, if you leave it for more than 3 days before
re-using it, you must re-erase it first. Refer to
on page 56.
4454C EN 2013-05-14
Identify at ID station
to use emergency data
Chest AP
When the CR 35-X returns the cassette, it is ready to be re-
BUSY
DIRECT ID
mode')'.
BUSY
CR 35-X D
IGITIZER
Chapter 3, 'Advanced
'Re-erasing an image plate'
Reading an image plate
47