AGFA CR 35-X User Manual page 45

4
Remove the cassette from the cassette slot.
WARNING:
used immediately. However, if you leave it for more than 3 days before
re-using it, you must re-erase it first. Refer to
on page 56.
Reading an image plate in the dedicated
configuration
Note: If the CR 35-X displays an error message, refer to
checklist'
In the dedicated configuration, the CR 35-X can digitize the image plate while
you are entering the identification data via the ID Station.
To read an image plate:
1
Check that the CR 35-X is ready for operation:
•
The CR 35-X must display the operator main screen with 'Ready' status, e.g.:
QS not ready
•
The status indicator at the top of the CR 35-X must be green and be lit constantly.
Note: The CR 35-X is operational if the status field equals 'READY', even if
status messages of the destination are shown (e.g. 'QS not ready').
2 Press the appropriate emergency button at the front of
The emergency button determines the speed class, i.e. the sensitivity, which will be
used to digitize the image plate.
4454C EN 2013-05-14
When the CR 35-X returns the cassette, it is ready to be re-
on page 65.
'Re-erasing an image plate'
Status field
READY
the
CR 35-X D
IGITIZER
'Troubleshooting
CR 35-X.
Reading an image plate
45