Reading the Initialization Data of an
Image Plate
The initialization data stored in the RF-tag of the tray can be read via the
CR 30-X.
Reading the initialization data of an image plate can be necessary in the
following cases:
•
to find a specific cassette,
•
to check if the IP sensitivity code (printed on the rear side of the IP) is
corresponding with the initialized data on the chip,
•
to check if the correct IP was inserted after cleaning (in case of doubt),
•
to check the cycle counter of the cassette,
To read the initialization data:
1
Check that the CR 30-X System is ready for operation:
The status indicator on the CR 30-X digitizer constantly lights up in green.
2385A EN 20060630
CR 30-X S
Advanced Function of the CR 30-X System
YSTEM
21