AGFA CR 35-X User Manual page 16

CR 35-X D
IGITIZER
• You can hurt your fingers if they are caught between the ADC Cassette and the
edge of the input slot. Insert the cassette in the input buffer as described in
'Reading an image plate'
input slot. As soon as the cassette enters the CR 35-X, release it.
16
Safety precautions
Power Off
Note that the power cord has to be disconnected from the wall
outlet in order to disconnect the unit entirely from the mains.
Precautions for use in USA only:
Make sure that the circuit is single-phase center-tapped, if the
Digitizer is connected to a 240 V/60 Hz source instead of a
120 V/60 Hz source.
Type label
Date of manufacture
Manufacturer
Serial number
WEEE symbol, see section
Device contains a transmitter module
on page 43. At all times, keep your fingers clear of the
Environmental Protection
4454C EN 2013-05-14