Switching Off The Cr 35-X - AGFA CR 35-X User Manual

Switching off the CR 35-X

Before switching off
Check that the CR 35-X is not scanning an image plate. If the CR 35-X is
scanning an image plate, the status indicator at the top of the machine is
green and flashing.
Switching off
It is recommended to switch off the CR 35-X at the end of the day.
WARNING:
Switching on the CR 35-X takes approximately 3 minutes. During this
time emergency digitizing is not possible!
Place the main switch in position '0'.
Note: After switch off, the device is still in stand-by mode. To remove the
device from the mains supply disconnect the mains plug.
4454C EN 2013-05-14
Leave the CR 35-X on if you intend to use it overnight.
CR 35-X D
IGITIZER
39
Switching off the CR 35-X