Messages - Teledyne CP Series User Manual

User Manual
CP Series
Version 3.1 – June 2020
Offset
Interface 0 HID Report Descriptor Vendor-Defined 1
Item Tag (Value)
Usage Page (Vendor-Defined 1)
Usage (Vendor-Defined 1)
Collection (Application)
Logical Minimum (0)
Logical Maximum (255)
Report Size (8)
Report Count (64)
Usage (Vendor-Defined 1)
Input (Data,Var,Abs,NWrp,Lin,Pref,NNul,Bit)
Report Count (64)
Usage (Vendor-Defined 1)
Output (Data,Var,Abs,NWrp,Lin,Pref,NNul,NVol,Bit)
End Collection
9.4 M
ESSAGES
In the communication protocol, there are three kinds of messages:
1. Order
2. Request
3. Reply or event
Every order or request will generate a reply from the PowerBox. It is recommended to wait for this reply
before sending a new sequence.
When in Remote mode, it is always possible to stop the shot by pressing the STOP button on the front
panel, or by turning the key OFF. That last solution also prevents the shot to start if the key is in that position
before the command to start the shot is sent.
Field
0 bLength
1 bDescriptorType
2 bEndpointAddress
3 bmAttributes
1..0: Transfer Type
7..2: Reserved
4 wMaxPacketSize
6 bInterval
Raw Data
06 00 FF
09 01
A1 01
15 00
26 FF 00
75 08
95 40
09 01
81 02
95 40
09 01
91 02
C0
beginning by #
beginning by ?
beginning by !
Size Value Description
1 07h
1 05h Endpoint
1 81h 1 In
1 03h Interrupt
......11 Interrupt
000000..
2 0040h 64 bytes
1 0Ah 10 ms
64