Screen; Carousel - Teledyne CP Series User Manual

User Manual
CP Series
Version 3.1 – June 2020
Note: If a problem occurs while upgrading the PBB100 software it may cause the main software is get
corrupted which will leave the PowerBox to become unresponsive after a restart. In this case, leave the
USB pen with the upgrade files in the PowerBox's master USB port, turn off the main switch (11), press the
"STOP" button (9) and keep it pressed while switching on again. Keep the "STOP" button pressed until you
can see on the display that the upgrade process has restarted.
5.4.9 S
CREEN
The brightness of the display can be set here. It is recommended to set
a lower 'Sleep Brightness' to extend the display's lifetime. The brightness
is selectable in 7 steps: Min > 2 >3 >4 >5 >6 >Max.by pressing the 'OK'
button while the submenu item is highlighted.
Working bright. Select the brightness of the display when the display is
active. i.e. when working in the PowerBox menu.
Sleep bright. : Select the brightness of the display when the display is
in standby. i.e. when not working in the PowerBox menu and for instance you are waiting for a shot to finish.
Standby time Set the time in seconds after which the display will revert to the standby. i.e.: Sleep
brightness. Value can be adjusted between 1 & 255 seconds.
5.4.10 C
AROUSEL
There are 5 positions of the carousel as illustrated in the CP SERIES
generator's component description chapter.
When the 'Control' is ON, the position of the carousel is verified by the
PowerBox to ensure it is correct before allowing a shot. For example, if
the carousel is on an in-between position, or on the laser pointer, it will
not be possible to make a shot.
When the 'Control' is OFF, the carousel is not monitored and the
operator will always be allowed to make a shot or a preheating,
regardless of the position of the carousel.
Note: When the electronic position verification is disabled, the user must verify visually if the carousel is in
the correct position!
The 'Position' submenu item shows the actual position of the carousel.
'Be-08mm' submenu allows or forbids the use of the beryllium window. This may be necessary if local
regulations prohibit the use of such low filtration. Please note that even when this option is allowed,
shots at higher than 50kV with the beryllium window are not possible.
'Preheat w/o shutter' allows or not the operator to perform a preheating if the carousel is not on the shutter
position

Screen

Working bright. max
Sleep bright. min
Standby time 10s
**********
Confirm

Carousel

Control ON
Position Be-0.8mm
Be-0.8mm Allowed
Preheat w/o shutter
**********
Confirm
Y
45