Installing Options; Available Options; Order Of Option Installation - Ricoh SP6330 Hardware Manual

2. Installing Options

This chapter explains how to install various options for this printer.

Available Options

By installing options, you can improve printer performance and expand the available features.
• Before installing options, the printer should be turned off and unplugged for at least an hour.
Components inside the printer become very hot, and can cause a burn if touched.
• Before moving the printer, unplug the power cable from the outlet. If the cable is unplugged
abruptly, it could become damaged. Damaged plugs or cables can cause an electrical or fire
hazard.
• When lifting the printer, use the grips on both sides. The printer could break or cause an injury if
dropped.
• The voltage rating of the connector for options is 24 V DC or less.

Order of Option Installation

Installing multiple options in the following order is recommended:
1. Attach the paper feed unit (Paper Feed Unit PB3090).
Attach the paper feed unit to the bottom of the printer.
You can attach up to two paper feed units. Up to 1600 sheets of paper can be loaded.
2. Attach the envelope feeder (Envelope Feeder Type 610).
Replace the paper tray of the optional feeder with the envelope feeder.
3. Take out the controller board from the printer.
4. Install the hard disk (Hard Disk Drive Type 2670).
Install the hard disk to the controller board.
5. Install the SDRAM module (Memory Unit Type G 128MB/ 256MB).
Install the module to the SDRAM module slot on the controller board.
There are two types of memory unit: 128 MB and 256 MB.
2
25