How To Set The User Parameters - Gestetner F540 Advanced Features

How to set the User Parameters

This section describes how to set the
User Parameters, using transmission
mode as an example. To change the
transmission mode from Memory
Transmission to Immediate Trans-
mission, you need to change the bit 6
of switch 00 from 0 to 1.
Important
❒ Do not change any bit switches
other than those listed in the previ-
ous section.
❒ Do not change the User Parame-
ters while the line is being used.
Communication may stop.
Note
❒ You can print the User Parameter
List to check the current settings.
However, only the items of much
importance or the items that you
often use are included in the list.
See p.148 "Printing the User Pa-
rameter List".
A A A A
Press the { { { { User Tools} } } } key.
B B B B
Press 0 0 0 0 or 1 1 1 1 until " 2. Fax Fea-
tures " is displayed.
C C C C
Press the { { { { OK} } } } key.
D D D D
Press 0 0 0 0 or 1 1 1 1 until "4. Key Op.
Tools" is displayed.
E E E E
Press the { { { { OK} } } } key.
Using Key Operator Settings
F F F F
Press { { { { 2} } } } { { { { 2} } } } { { { { 2} } } } { { { { 2} } } } .
G G G G
Press the { { { { OK} } } } key.
H H H H
Press 0 0 0 0 or 1 1 1 1 until "11. User Pa-
rameters" is displayed.
Note
❒ The code for each function that
appears on the display varies
depending on the installed op-
tions or functions settings.
I I I I
Press the { { { { OK} } } } key.
J J J J
Depending on the setting you re-
quire, use one of the following
procedures:
Changing the User Parameters
A Press 0 0 0 0 or 1 1 1 1 until "1. Change"
is displayed.
B Press the { { { { OK} } } } key.
Confirm that switch 00 is dis-
played.
Note
❒ To display other switches,
press 0 or 1.
C Press number key { { { { 6} } } } to
change the value of bit 6 to 1.
7
147