Table of Contents
Advertisement
Other Transmission Features
No Document, No Dial
If you dial a destination fax number
and for some reason take your docu-
ment back to your desk and another
person places a different document,
their document could be sent to the
wrong destination. To avoid such
mistakes, when this feature is turned
on, you cannot dial a destination un-
3
less your document is set.
Note
❒ The standby display when this fea-
ture is turned on.
❒ This feature is turned off by de-
fault. If you want to turn this fea-
ture on, please contact your service
representative.
Blank Sheet Detect
This feature is designed to help you
avoid making mistakes while scan-
ning documents.
If you try and scan in an almost com-
pletely blank original, an alarm
sounds and the following display ap-
pears. Make sure the original is not
blank.
Limitation
❒ This feature is not supported in
copier mode.
Note
❒ Transmission is not cancelled even
if the machine detects the original
is blank.
58
❒ With Memory Transmission, the
alarm sounds as soon as the origi-
nal has been scanned. To cancel the
transmission, press the { { { { Clear/Stop} } } }
key while the "
Some Page(s) are
" is appears on the display.
Blank
❒ You can turn Blank Sheet Detect on
or off with the User Parameters.
See p.138 "User Parame ters"
(switch 11, bit 2).
Scanner Cleaning Message
If dirt is stuck to the scanner, the other
party receives fax messages with
black lines. When the scanner is dirty,
the warning message "
tact Glass and White Strip
displayed after scanning is complete.
If this message is displayed, wipe the
contact glass and white strip to re-
move the dirt, and then press the
{ { { { OK} } } } key.
Note
❒ You can select whether this mes-
sage is displayed or not when the
machine detects that the scanner is
dirty with the User Parameters.
"On" (Displayed) is selected by de-
fault. See p.138 "User Parameters"
(switch 20, bit 7).
❒ If the dirty part of the scanner is
small, that is, 0.127 mm (0.005 in.) or
smaller, the machine tries to erase
the black line made when scanning
originals. The black line is less visi-
ble on the received message. How-
ever, sometimes very small parts of
the image might be missing on the
received message. You can turn this
function on or off with the User Pa-
rameters. It is turned on by default.
See p.138 "User Parame ters"
(switch 20, bit 4).
❒ Transmission is not interrupted
even if the machine detects that the
scanner is dirty.
Clean Con-
" is
Advertisement
Table of Contents
