Table of Contents
Advertisement
Reception Features
H H H H
Specify the end receiver, and then
press the { { { { q
If the End Receiver is correct, you
will hear a "peeee" tone.
Specifying the end receiver with a
Quick Dial key
A Enter the number (01-90) of the
Quick Dial key.
Specifying the end receiver with a
Speed Dial
4
A Press the { { { { p
enter the Speed Dial code (000-
199).
Note
❒ If the End Receivers only
support 2 digits for the Speed
Dials, enter the number with
2 digits.
Specifying the end receiver with a
Group Dial
A Press the { { { { p
then enter the group number
(1-9).
Note
❒ Specify an end receiver that
has been stored in a Quick
Dial key , Speed D ial, o r
Group Dial.
❒ If you hear a "pee pee pee
pee" tone, specify the end re-
ceiver again.
❒ If you keep on getting the er-
ror tone, the End Receiver
may not be registered in the
destination you are specify-
ing.
74
q } } } } key.
q
q
p } } } } key, and then
p
p
p } } } } key twice, and
p
p
I I I I
Repeat step H H H H for all End Receiv-
ers.
Note
❒ If you specify 30 End Receivers,
the Transfer Request is accepted
and you will hear a "pee pee pee
pee" tone. In this case, proceed
to step K.
J J J J
Press the { { { { q
q } } } } key twice.
q
q
The Transfer Request is accepted
and you will hear a "pee pee pee
pee" tone.
K K K K
When you hear the reception tone
again, press the { { { { Start} } } } key.
Your document will be sent.
ID Reception
If you want to limit reception of mes-
sages to those from machines of the
same make and with the same Polling
ID, contact your service representa-
tive to enable this feature.
Reference
p.148 "ID Codes"
p.52 "ID Transmission"
JBIG Reception
Use this feature to receive messages
sent to you using the high compres-
sion protocol known as JBIG (Joint Bi-
level Image Experts Group).
Reference
p.59 "JBIG Transmission"
Advertisement
Table of Contents
