Setting Up The Communication Software - Furuno Felcom 82 Operator's Manual

6. 9.6k DATA COMMUNICATIONS
6.4.3

Setting up the communication software

The setup procedure varies depending on the communication software used.
This section only mentions the points you should give attention to.
Number of remote stations
If an LES is specified with the +WLES command, do not specify an LES number.
If not, specify this number including an LES number.
Communication format
This format varies depending on the remote station you are connecting to.
Properly set the communication format according to that station.
Flow control
In principle, set this parameter to the hardware control (CTS/RTS). Choose the
software control (XON/XOFF) if necessary, e.g., when the hardware control
cannot be used by the terminal.
Note: For further information, refer to the instruction manual of the
communication software.
6-9