Table of Contents
Advertisement
2.11
Setting Date, Time
This section shows you how to input date and time and choose time format and
time zone.
Note 1: This procedure is done from the Administration mode. See page 2-10 for
how to choose the Administration mode.
Note 2: Input of date and time are not necessary when the system is interfaced
with a GPS navigator and it is functioning.
Date and time
1. Press [FUNC Quit], [6] and [4] to show the Date&Time menu.
2. Press the [1] key to select "1 Date&Time."
3. Enter year in four digits, and date, month and day in two digits each including
leading zero where necessary. Use the [ ] or [ ] key to select location.
4. Press [ ].
5. Key in UTC time and press the [Ent] key.
6. Press the [FUNC Quit] key several times to close the menu.
If you enter invalid data the message "Input Error! Input data is invalid." Is
displayed and three seconds later the main menu appears.
6 4 D a t e & T i m e
1
D a t e & T i m e
2
D a t e
F o r m
3
T i m e
Z o n e
S e l e c t : [ E n t ]
Date&time menu
6 4 D a t e & T i m e
D a t e :
2 0
0
0 - 0 3 - 0 1
T i m e
0 0 : 0 0 ( U T C )
E n t e r : [ E n t ]
Date&time input screen
2. SETTING UP
2-19
Advertisement
Table of Contents
