Setting Destination - Furuno GP-1610C User Manual

Setting Destination

When you set a destination, this unit computes the range, bearing and course to the destina-
tion. To display your destination on the screen select a small display range or scale. To set as
destination a point which is 20 nm from your harbor do the following:
Shrink display
range or scale.
Destination
point
Set point as
destination.
If "Cursor/Route plan"
is not in reverse video,
press to do so.
8
CSE 180.0 SPD 0.0kt 2D
DEP 110 m TMP - - .- C 14:40
POS 34 26.345'N 135 41.232'E
1 Press the ZOOM OUT key.
Press until position
for destination
appears.
CSE 180.0 SPD 0.0 kt 2D
DEP 110 m TMP - - .- C 14:53
POS 34 26.345'N 135 41.232'E
2 Press the GOTO key.
SELECT GOTO MODE
WPT List
EVENT List
ROUTE List
Cursor/Route plan
ENT: Sel CLR: Release
ESC: Cancel
MENU NU/CU
ESC ENT
DISP
EVENT
SEL 1
MOB 6
2
WPT
GOTO
2 7
MARK PLTR
3 8
1
ZOOM
ZOOM
IN 4
OUT 9
CURS
CNTR
0
5
TONE
CLR
POWER