Finishing A Communication - Furuno Felcom 82 Operator's Manual

6.5.5

Finishing a communication

Disconnection by the remote station
The satellite link is disconnected with "NO CARRIER" displayed. A different
message may be displayed depending on your communication software.
Disconnection by the MES
To finish the communication at the MES:
1. Use the ER (DTR) signal to disconnect the communication line.
a) Set up the MES and communication software beforehand as follows:
1- Set up the MES so that the line is disconnected with the AT&D2 {ER (DTR)}
signal.
2- Set up the communication software so that the line is disconnected with the
ER (DTR) signal.
b) If the line is disconnected with the communication software during a
communication, the communication can be finished.
2. Go to the on-line command mode with the break signal and then use the ATH
command.
a) Previously set up the MES as follows:
1- Using the AT K command (to choose the break signal processing), set up
the MES so that it enters the on-line command mode with the break signal .
b) Send the break signal from the communication software.
c) The MES enters the on-line command mode.
d) Enter the ATH command from the communication software. The
communication is finished.
Note: The first procedure is recommended.
6. 9.6k DATA COMMUNICATIONS
6-11