Table of Contents
Advertisement
Multi Edit Mode
Channel Page
Add
Use the Add parameter to offset the value of the selected controller for each Zone. The
Add parameter offsets the current value of the controller by the selected Add amount (-128
through 127). Press the MULTI Mode button to quickly apply the selected value.
The Add parameter effectively allows you to apply different values to each Zone, while
maintaining a single value for each controller. For example, with the Ctl parameter set to
Reverb, you could set the Zone 1 Add parameter to 0, and the Zone 2 Add parameter to 10.
With the REVERB knob set to 0, Zone 1 would have a Reverb value of 0, and Zone 2 would
have a Reverb value of 10. With the REVERB knob set to 15, Zone 1 would have a Reverb
value of 15, and Zone 2 would have a Reverb value of 25.
Channel Page
Use the Channel Page to select a MIDI Channel and Destination for each Zone.
The Chan and Destination parameters are useful when using the SP6 to send MIDI to
external equipment, or when receiving MIDI from external equipment. If you are not using
external MIDI equipment, these parameters can be left at their default values.
Chan
The Chan parameters set the MIDI transmit and receive channel for each Zone.
For most uses, each Zone should be set to a different MIDI channel. If you set multiple
Zones to the same MIDI channel, the same Program will be used for each of those Zones.
Destination
The Destination parameters determine where MIDI data generated from each Zone is sent
when playing the SP6 keyboard and moving the SP6 controllers. MIDI data from each
Zone can be sent to a SP6 Program (LOCAL), to the MIDI OUT port (MIDI), to the USB
COMPUTER port (USB), or to any combination of these destinations.
5-10
Advertisement
Table of Contents
