Table of Contents
Advertisement
Program Mode
Changing the Transmit MIDI Channel
Layer Transposition
This parameter determines the transposition of the Secondary Voice relative to that of
the Primary Voice—it can be set to -24, -12, 0, 12, and 24. By default, Layer Transposition
is set to 0. Note that if the Primary Voice is transposed, then the Secondary Voice will be
transposed by the same amount in addition to being transposed by the amount set for the
Layer Transposition.
Changing the Transmit MIDI Channel
Pressing the Chan / Param Up (
channel, incrementing or decrementing it respectively. Pressing both Chan / Param Up (
and Down (
The MIDI channel will be shown briefly in the display before the display changes back to
showing the current Program on the selected MIDI transmit channel.
Saving in Program Mode
When you make a change to the current Program using the Control Knob, the Save button
LED will light up indicating that a change has been made to the Program. To save the
current Program, press the Save button once. The Save button LED will blink to indicate
that a save operation is underway, and the User Bank LED will also be lit. If the program is
an edited Factory Program (i.e., a Program in Bank 1 or Bank 2), the default save location
will be the next available location in the User Bank. If all 64 User Bank slots are taken, then
6-10
̂
̌
) at the same time will reset the current MIDI channel to 1.
̌
) or Down (
) button will change the MIDI transmit
̂
)
Advertisement
Table of Contents
