Kurzweil SP6-7 Musician's Manual page 30

Program Mode
Controllers
SW1 (SUSTAIN) and SW2 Pedals
The SW1 (SUSTAIN) pedal defaults to controlling Sustain, which will sustain any note that
is played while the pedal is pressed, for as long as the pedal is held.
The SW1 (SUSTAIN) jack is compatible with continuous switch pedals (Half-Damper) that
use a 1/4 inch tip-ring-sleeve plug (such as the Kurzweil KP-1H). When connected to the
SW1 (SUSTAIN) jack, a Half Damper pedal enables finer control of Sustain than a standard
switch pedal. Half Damper control is enabled for Programs in the Piano category. Programs
outside of the Piano category will respond to a Half Damper pedal as if it is a standard switch
pedal.
For KB3 Organ Programs, the SW1 (SUSTAIN) pedal controls the Rotary Speaker speed,
changing between fast and slow. The LCD display shows "KB3" when a KB3 Program is
selected.
The SW2 pedal defaults to controlling Sostenuto, which will sustain notes from any keys that
are being held when the pedal is pressed, for as long as the pedal is held.
Global Mode can be used to set pedal overrides, which can change the pedal assignments for
all Programs.
CC (VOLUME) Pedal
The CC (VOLUME) pedal is assigned to control Program volume (pre-FX).
For KB3 Organ Programs, the CC (VOLUME) pedal controls organ swell. Organ swell is
similar to Program volume, except volume can not be turned all the way down to silence.
The LCD display shows "KB3" when a KB3 Program is selected.
2-6