Table of Contents
Advertisement
A value of "None" can be selected by using the ALPHA WHEEL to scroll below 0. This
is useful if you wish to manually set Zone volumes with the SP6 knobs, rather than using
default values when the Multi is selected. A value of "None" will use the last volume value
used by the Zone's MIDI channel (a MIDI channel from the previously selected Multi, or
from Program Mode).
Pan
The Pan parameter sets the panning (left/right stereo placement) of each Zone. Change
the panning of a Zone by using the ALPHA WHEEL, or use the keypad function of the
CATEGORY buttons to type a pan value (0-127) followed by pressing the ENTER button.
A value of 0 is full left, 64 is center, and 127 is full right. Other values will move the stereo
placement in between these positions.
A value of "None" can be selected by using the ALPHA WHEEL to scroll below 0. A value
of "None" will use the last pan value used by the Zone's MIDI channel (a MIDI channel
from Program Mode or from the previously selected Multi).
Key/Velocity Page
Key Low / Key High
The Key Low and Key High parameters set the playable key range of each Zone by setting
the lowest and highest playable key of each Zone. Keys played within this range will trigger
a note for the selected Zone. (You can also set a range where playing keys will not trigger a
note, by setting Key Low to a higher key than Key High).
A Value for the currently selected Key Low or Key High parameter can be selected by
holding down the ENTER button and then playing the desired key on the keyboard. Values
can also be selected by using the ALPHA WHEEL, or by using the keypad function of the
CATEGORY buttons, followed by pressing the ENTER button.
Multi Edit Mode
Key/Velocity Page
5-3
Advertisement
Table of Contents
