Table of Contents
Advertisement
Program Mode
SPLIT/LAYER
3. On the "Split or Layer" Page, use the PREVIOUS or NEXT buttons to select "Split
<ENTER>", then press the ENTER button.
4. On the "Split" Page, Zone 2 is selected with a default Bass Program selected for the left
hand of the Split. Use the ALPHA WHEEL or CATEGORY buttons to select a different
Program for the left hand of the Split.
5. Additional Split parameters are described in
Use the CHANNEL/PAGE buttons to navigate between each of the 3 Split function
pages. Use the PREVIOUS or NEXT buttons to select each parameter, and the ALPHA
WHEEL or CATEGORY buttons to change the value of each parameter.
6. Press the SAVE button to save your Split as a Multi (See below for details on saving).
After saving your Split Multi, you can edit additional Multi parameters in Multi Edit
mode.
LAYER
When you create a Layer in Program Mode, you are creating a Multi with two Zones set to
On.
The Program you were using in Program Mode is used for the Zone 1 Program. You can
choose a Program that will be used as the layered Zone 2 Program.
Follow these steps to create a Layer:
1. In Program Mode, select a Program that you wish to layer.
2. Press the PREVIOUS and NEXT buttons simultaneously to access the "Split or Layer"
Page.
3. On the "Split or Layer" Page, use the PREVIOUS or NEXT buttons to select "Layer
<ENTER>", then press the ENTER button.
4. On the "Layer" Page, Zone 2 is selected with a default layer Program selected for the
layered Zone 2 Program. Use the ALPHA WHEEL or CATEGORY buttons to select a
different Program for the layered Zone 2 Program.
2-8
Split/Layer Parameters on page
2-9.
Advertisement
Table of Contents
