Table of Contents
Advertisement
Shift Limit
When the Shift parameter is set to a value other than 0, Shift Limit determines how far up or
down the Arpeggiator can shift the arpeggiated notes.
Limit Option
The Limit Option parameter determines what the Arpeggiator does when it has shifted the
currently arpeggiated notes up (or down) to the value set by the Shift Limit parameter. Select
from the following settings:
Reset: When the Arpeggiator reaches the Shift Limit, the Arpeggiator returns to its original
pitch.
Unipolar: When the Arpeggiator reaches the Shift Limit, the Arpeggiator begins shifting
notes in the opposite direction, until it reaches the original pitch. When the Arpeggiator
reaches the original pitch, it reverses direction again.
Bipolar: When the Arpeggiator reaches the Shift Limit, the Arpeggiator begins shifting notes
in the opposite direction, until it reaches the shift limit in the opposite direction, where it
reverses direction again.
Master Page
Use the Master Page to control overall settings of the current Program.
PBendUp and PBendDwn
Use these parameters to set how much the pitch will change when you move the PITCH
WHEEL up or down. For both Pitch Bend parameters, positive values will cause the pitch to
bend up, while negative values will cause the pitch to bend down.
Pitch bend values are set in cents (ct), where 100 cents equals 1 semitone (also known as a
half step).
Large positive values can cause samples to bend to their maximum upward pitch before the
PITCH WHEEL is fully up (or down). This will not happen when bending pitch down.
Program Edit Mode
Master Page
3-5
Advertisement
Table of Contents
