Platform Height Sensor - Terex Genie GS-1532 Service And Repair Manual

Service and Repair Manual
Scissor Components
9-8

Platform Height Sensor

How to Disassemble the Platform
Height Sensor Assembly
(if equipped)
Note: When a Platform Height Sensor Assembly is
removed or replaced, the platform overload
system must be calibrated. Refer to Repair
Procedure, How to Calibrate the Platform
Overload System (if equipped) and follow the no
load calibration procedure.
1 Raise the platform 7 to 8 feet / 2,1 to 2,4 m.
2 Lift the safety arm, move it to the center of the
scissor arm and rotate down to a vertical
position.
3 Lower the platform onto the safety arm.
Crushing hazard. Keep hands
clear of the safety arm when
lowering the platform.
4 Turn the key switch to the off position.
5 Disconnect the battery pack from the
machine.
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
6 Remove the fasteners securing the large
platform height sensor cover to the large
platform height sensor bracket.
126
7 Remove the platform height sensor cover.
8 Tag and disconnect the platform height
sensor from the platform height sensor
harness.
9 Remove the fastener securing the platform
height sensor assembly to the number 1 inner
arm.
10 Remove the platform height sensor assembly
from the number 1 pivot pin.
11 Remove the set screw securing the lever arm
to the platform height sensor.
12 Remove the lever arm from the platform
height sensor assembly.
13 Working with the platform height sensor
assembly, remove the Deustch connector
from the plastic clip.
14 Remove the fasteners securing the platform
height sensor to the small platform height
sensor bracket.
GS ™ -30 • 32 • 46 • 47
Steer End
1 fasteners (platform height sensor cover)
2 platform height sensor cover
Part No. 1272217GT
March 2021