Control System; 1 Alc-600 Platform Control Module - Terex Genie S-40 XC Service And Repair Manual

Service and Repair Manual

Control System

1-1
ALC-600 Control Module
Platform Controls
The platform control box contains the ALC-
600 platform Control Module. The platform Control
Module receives all signals from the platform
switches, joysticks and foot switch, and provides
operator feedback through an Indicator Module.
The joystick controllers at the platform controls
utilize Hall Effect technology and require no
calibration. Automatic calibration of center voltage
occurs on power up if the signal value is in the
valid range. Each joystick controller should
operate smoothly and provide proportional speed
control over its entire range of motion. The
remaining boom functions operate by on/off toggle
switches.

1 ALC-600 platform control module

2 primary boom up/down and turntable
rotate left/right joystick controller
3 LED indicator module
4 drive/steer joystick controller
20 S -40/45 XC • S -40/45 HF • S
® ™ ®
1-2
How to Enter ALC-600 Service
Mode
ALC-600 Control System Display
1 Number 1 or Escape
2 Number 2 or UP arrow
3 Number 3 or DOWN arrow
4 Number 4 or OK
5 Settings menu
6 USB drive detected
7 Faults menu
8 Fault LED Indicator
9 Engine hours
10 Maintenance LED indicator
11 Maintenance menu
12 Home menu
-40/45 TraX
® ™
February 2023
Part No. 1286829GT