Siemens SITRANS L Operating Instructions Manual page 167

9.3.1 Unit repair and excluded liability
All changes and repairs must be done by qualified personnel, and applicable safety
regulations must be followed. Please note the following:
• The user is responsible for all changes and repairs made to the device.
• All new components must be provided by Siemens.
• Restrict repair to faulty components only.
• Do not re-use faulty components.
9.3.2 Part replacement
If the antenna, lens, secondary O-ring, and spring washers require replacement due to
damage or failure, they may be replaced without the need for re-calibration if of the same
type and size.
Replacing the antenna
Changing to a different antenna type may be performed by a Siemens authorized repair
center or personnel.
If the electronics or enclosure require replacement due to damage or failure, please ensure
the correct antenna version is used, otherwise a re-calibration will need to be performed by
Siemens authorized personnel.
Replacing the lens
1. Remove existing lens by turning it counter-clockwise until it separates from the unit.
2. Replace the O-ring between the lens and process connection with a new one.
3. Carefully thread the replacement lens, and turn it clockwise until resistance is encountered.
Do not over-tighten the lens, as this will permanently damage it.
4. For flange installation instructions, see Flanged versions (Page 32).
Note
After installation of the new lens onto the flanged encapsulated antenna version and before
mounting on the vessel/tank, some lenses may not appear to lie flush on the device, but this
is normal and will not impact performance.
Raised-Face flange kits
Description
Replacement TFM 1600 PTFE Lens and Spring Washer Kit
TM
for ASME B16.5 Class 150 raised faced
SITRANS LR250 with FOUNDATION FIELDBUS
Operating Instructions, 09/2021, A5E32221411-AH
9.3 Maintenance and repair work
Process con-
nection size
2"
3"
4"
6"
Service and maintenance
Part number
A5E32462817
A5E32462819
A5E32462820
A5E32462821
167