Ethernet Setup - Crestron TSS-70 Series Product Manual

Ethernet Setup

Tap Ethernet Setup on the Setup screen to display the Ethernet Setup screen.
Ethernet Setup Screen
Use the Ethernet Setup screen to view the touch screen MAC and IP addresses, subnet mask
address, default router address, primary and secondary DNS addresses, hostname, and domain.
A Link indicator is provided to indicate the status of the Ethernet connection. (Green indicates
that the Ethernet connection is active.)
The following buttons are provided for configuring Ethernet settings:
Tap On or Off under LAN Access to turn the Ethernet adapter on or off. If LAN Access is
l
set to Off, Ethernet will not function and a Wi-Fi connection can be established.
Tap On or Off under DHCP Enable to turn DHCP (dynamic host configuration protocol) on
l
or off.
NOTE: DHCP is turned on by default.
If DHCP is turned off, tap Set Static IP Address Settings to enter static IP addresses
l
manually.
Tap Set Hostname to enter a new touch screen hostname using an on-screen keyboard.
l
Tap APPLY CHANGES to apply any new Ethernet settings to the touch screen and to stay
l
in setup mode.
Tap REBOOT to exit setup mode and reboot the touch screen.
l
To change a static IP address, tap Off under DHCP Enable. Then, tap Set Static IP Address
Settings to display the Static IP Ethernet Setup screen.
54 • TSS-70 Series Product Manual — Doc. 8745D