Table of Contents
Advertisement
Installation
Use the following procedures to install the TSS-770 and TSS-1070 touch screens.
Install the Mounting Bracket
The TSS-770 and TSS-1070 install over a standard 2-gang or 3-gang U.S. electrical box, a 2-gang
European electrical box, or a 2-gang U.K. electrical box. The touch screen also installs into
drywall.
NOTES:
Additional mounting options are possible using the following mounting accessories. For
l
more information, refer to the product pages at www.crestron.com.
TSW-UMB-70 universal mounting bracket
o
TSW-UMB-70-PMK preconstruction mounting kit
o
TSW-UMB-70-BBI wall mount back box
o
TSW-770/1070-MSMK series multisurface mounting kits
o
TSW-770/1070-MUMK mullion mounting kit
o
TSW-770/1070-RMB series retrofit mounting brackets
o
TSW-770/1070-RMK series rack mount kits
o
Installing the mounting bracket to an electrical box is required only if one of the
l
mounting solutions above is not used. Refer to the documentation for your chosen
mounting solution at www.crestron.com/manuals.
Electrical Box Mounting
To mount the touch screen into an electrical box, use the appropriate screws (four 6-32 x 3/4 in.
screws, four M3 x 16 mm screws, or two M3.5 x 25 mm screws) to attach the mounting bracket to
the electrical box as shown in the following illustrations:
NOTE: For U.S. installations, use a #2 Phillips screwdriver. For European or U.K. installations,
use a #1 Phillips screwdriver.
40 • TSS-70 Series
Product Manual — Doc. 8745D
Advertisement
Table of Contents
