Agilent Technologies 5110 ICP-OES Service Manual page 264

9 iTroubleshoot/Parts Predict
Problem Solving Table
Table 1
Symptom Area Problem
Water Cooling Water Cooling Ready LED Red
Water Cooling Water Cooling Ready LED Red
Water Cooling Water Temperature high
Wavelength calibration Fails calibration at high and low
wavelengths
Wavelength calibration Fails calibration at high and low
wavelengths
Wavelength calibration Fails calibration at high and low
wavelengths
Wavelength calibration Fails calibration at high and low
wavelengths
Wavelength calibration Fails calibration at high and low
wavelengths
Wavelength calibration Fails calibration at high and low
wavelengths
Wavelength calibration Fails Calibration at low
wavelengths only
Wavelength calibration Fails Calibration at low
wavelengths only
Wavelength calibration Fails Calibration at low
wavelengths only
264 Agilent Restricted
Problem Description
Water Temp out of spec
Water Temp out of spec
Chiller Air inlet obstructed
Argon Ratio incorrect
Calibration solution
Moisture on Detector Lens
Optimize Pre optics
Realign Polchromator
Replace Camera
Fails low wavelengths
Windows Contaminated
Holes in Optics not sealed
Agilent 5110/5100 ICP-OES Service Manual
Solution
Replace Temp sensor
Replace Instrument Control PCA G8010-65200
Clean filter - Ensure air flow
around chiller
Adjust Argon Ratio
Use Fresh calibration solution
Purge gas contaminated. Verify
using Polyalign. Should be no
peaks with Shutter closed.
Switch off Chiller and wait 30
minutes and then retry.
Optimize Pre Optics using Mn
Line
Realign Polychromator including
Focus
Replace Camera as a last resort
Increase purge time, Ensure
Boost purge, cone and snout
purge are on.
Clean or replace Axial or Radial
Windows
Check for grommet sealing
around Optics and no screws
missing
Part Number(s)
6610030100
G8014-60100
G8010-68014,
G8010-68015