Kia Cerato 2021 Manual page 652

Maintenance
5. Remove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
OBD071048
6. Remove the bulb from the socket
by pressing it in and rotating it
counterclockwise until the tabs on
the bulb align with the slots in the
socket. Pull the bulb out of the
socket.
7. Insert a new bulb by inserting it
into the socket and rotating it
untilit locks into place.
8. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assem -
bly.Push the socket into the
assembly and turn the socket
clockwise.
9. Install the rear combination lamp
assembly to the body of the vehi -
cle.
10.Install the service cover.
8 98
Stop/Tail lamp (Bulb type) bulb
replacement - 5 door type A
1. Open the tail gate.
2. Loosen the light assembly retain -
ing screws with a cross-tip
screwdriver.
OBD071047L
3. Remove the rear combination
lamp assembly from the body of
the vehicle.
4. Disconnect the rear combination
lamp connector.
OBD071047
5. Remove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
Light bulbs